Enzio wrote:
Like so.....hehehe
http://www.build-threads.com/build-threads/turbo-ktm-950-supermoto/
Looks easy enough 😮
Project See Why.
Lol. V = Twin turbo
Enzio wrote:
Like so.....hehehe
http://www.build-threads.com/build-threads/turbo-ktm-950-supermoto/
This is just crazyyyyy.
Dropped the subframe in order to do long over due bush replacement. Looks like I'll be replacing the wheel bearing as well :facepalm:
Hoe so?
Ero_sennin wrote:
Hoe so?
Hulle lyk nie soos ek wil he hulle moet nie.
Charlvdw wrote:
Ero_sennin wrote:
Hoe so?
Hulle lyk nie soos ek wil he hulle moet nie.
like jy hulle meer groen 😂
300sx wrote:
Charlvdw wrote:
Ero_sennin wrote:
Hoe so?
Hulle lyk nie soos ek wil he hulle moet nie.
like jy hulle meer groen 😂
Gedink aan swart, die rooi werk nie meer vir my nie. 😀
Got the my stuff back from the powder coaters, minus one washer. 😈
Then I thought, while I'm at it lets check out the diff.
Hey Charl...good job with the rear end. I need to do the same on the 300. I need to replace all the bushes as well, were any of them a bugger to remove, I know one of them has sleeve which does not come with the energy kit...I think? Did you have to burn out any of them?
Whats the going rate to powder coat all those parts.
Looks good I must say.
Tony
antman wrote:
Hey Charl...good job with the rear end. I need to do the same on the 300. I need to replace all the bushes as well, were any of them a bugger to remove, I know one of them has sleeve which does not come with the energy kit...I think? Did you have to burn out any of them?
Whats the going rate to powder coat all those parts.
Looks good I must say.
Tony
Hey Tony
All of them were kak to get out :facepalm:
I pressed them out but you still need to cut out a sleeve here and there.
Powder coating were R450.
I am dreading doing that job, I dont have a press so I will burn the rubber bush out, will definately have to powder coat after the heat treatment to prevent rust.
So whats next on your build, why you opened up the diff....was it faulty or you just wanted to whats inside...ha ha ha. 🙂
antman wrote:
I am dreading doing that job, I dont have a press so I will burn the rubber bush out, will definately have to powder coat after the heat treatment to prevent rust.
So whats next on your build, why you opened up the diff....was it faulty or you just wanted to whats inside...ha ha ha. 🙂
Just wanted to check it out. No curiosity at all. 😉 😉
And while the diff is apart....
nice dude looks good
SonOfAnarchy ZA wrote:
nice dude looks good
Thanx Jason.
Ey lookin good man, wish I had the energy to do that. . . Would love to stripp the suspention for a good polish up too
Sent from some crappy hand held device.
Had to do it sometime. 🙂
lyk goed!
Jis daai taffeltjie is al so baie kleure gewees 😁
522 posts
Sign in to reply.