Help!!

How would you know if its to slow or fast?

You have to go into the com port adjustment under settings, amin and adjust it there...you have to keep doing it till you get a good speed...lower is normally better.

I just found your post on SNS, so the RS232 to USB is fine? I dont need a com to com cable?

Settings are 9600bits per sec, 8 data bits, parity none, stop bits 1, flow control none

Check what the bit rate is on the mr. turbo, then mach that and the rate on the port

Ok thats going to be hard to find but will look, does it matter if im using windows 7?

wat i find wierd is when you turn you lights on it dies wtf???? wierd

weak altinator low voltage to ecu?

i was thinking that but there would be a problem with starting then

We thought it might be the batt or the altinator, the batt was not charging, put in new(used batt lying around), it was charging and seemed better, would idle okish and sometimes die, so i have no clue whats up, could it be the altinator? how would i test

fisrt just start your car there should be 13.5 to 14v across the batt + and -

There is +-13.5v yes

Grant222 wrote:

Ok thats going to be hard to find but will look, does it matter if im using windows 7?

I do not think Mr. turbo will work with win 7 but it's possible I guess.

I think im getting signals from car gods, went to clean one of the spare pistons to measure up etc and a piece of it just fell off, mustof been cracked and the cleaning movements loosend it?? Its time to stop wasting money, let it sit and wait for 2j...

Think iv got it sorted, took it for a drive and when the fans come on it doesnt even atempt to drop revs etc, choke works alles!!!!!!!!!!!!

Problem?

Redid all my ground wires and cleaned all the connectors

Well done!!

You See , Thats a sign , You must become a Auto electrician ,

Hahah, maybe, its too much trouble to do lol