wing question

does anyone reading this have a sentra (no, a real one) STI with the standard raised boot spoiler? i have looked at it and it will look nice on the s13.
measure it and post it here plz - need to know if itl fit

does anyone reading this have a sentra (no, a real one) STI with the standard raised boot spoiler? i have looked at it and it will look nice on the s13.

Very interesting 🙄 🙄 🙄

its been bugging me long time, just dont wanna measure samwan's car in a parking bay 🙂

im not going the trolley-wing way, and the aftermarket ones, well most of them look a bit, well aftermarket

m not going the trolley-wing way, and the aftermarket ones, well most of them look a bit, well aftermarket

Aagh no man Widomaker, how must I feel now? 😳 😳 🙄

well, i didn't say that it looked tappet now, did i ?

hehehe
just pulling your wire, yours are kewl, its just a personal thing

and how fast can this chemcool really run?

😀

I had a Genuine Carbon Fibre Touring Wing that i could of put on my white sx, which came off my honda ballade i had. But i decided i prefer the smooth look at the boot. The bootlid is now smoothed the standard boot spoiler is off.

Just my opinion.

I like the aftermarket ones, but if you do put one on, i know its mostly cosmetic, but doesnt it create a lot of drag? How do you adjust it without a wind tunnel?

Charl wrote:

I like the aftermarket ones, but if you do put one on, i know its mostly cosmetic, but doesnt it create a lot of drag? How do you adjust it without a wind tunnel?

Ja you get these FONG-KONG mokups wings they might not work... But the real deal wings out there creates a shit load of down force, and you adjust it via trial and error... Do you really think the D1 drift cars have access to a wind tunnel?

imo are wings mostly cosmetic - no need serious speed to be starting to be affected by a little piece of crabby-patty

if they made so much drag then nissan (or any other manufuckturer) would have put reinforcements in the bootlid

Ok So it's almost a year later!!

but ja here are the measurements:

1260mm across and 300mm wide at the ends....

Im looking for a direct replacement to the standard one - I dont really wanna cover holes and respray - are their any nice looking wings that fit straight on ?

talk about razing the dead

Hahaha worth a try - I think its horrid when post just end with no result :200sx_2guns:

Just posted a pick of my S13 with the Sentra wing check Macnellos new topic about Wing replacement