Ca18det spluttering or hesitating when I accelerate

RRichard25 Mar 2010, 16:19

Hi Guys, my car hesitates when I accelerate and seems to want to cut out.
It seems like the timing is not advancing. If I leave the accelerator a bit, it moves a little better but is totally dead uphill.
Any help would be appreciated.

RRichard25 Mar 2010, 16:28

I also check the fault codes on the ECU, it's 21.

ppoizenmoderator25 Mar 2010, 18:04

code 21 is your ignition system so you need to check your wires for the ignition it has a break in it somwhere

RRichard26 Mar 2010, 08:09

Will check with my limited knowledge.

ppoizenmoderator26 Mar 2010, 08:48

it could be that your ignitor is gone or anything that the prob with these sx's everything is wiring and after 16years wires get black death mine has it in few places so it going to be hard to trace basicly take each coil out and see if its sparking

else try get a fsm it has all the diagrams and procedures to take

rratadmin26 Mar 2010, 09:00

i had a problem with my fuel pump and it did something like that. but think the error code is a good start.

RRichard26 Mar 2010, 09:20

My car initially would not start, there was no spark so I reconditioned the ignitor, found that my ecu was the actual problem, replaced it with a second hand unit from Draco, car started but now have this problem. Checked fuel pump and coils, all seem fine. This problem only happens under load.

ppoizenmoderator26 Mar 2010, 09:33

does it hapen when you in boost or out boost try go up in the revs without boosting you need boost gauge for this if it doesnt do it on neg boost till 5k or 6k rpm then you have a boost pipe thats leaking or poped off thats how i got my sx found the car was dead and would try die when boosted it was a pipe that came off my intercooler

RRichard26 Mar 2010, 10:23

Does not reach 5000 rpm, does this as soon as I accelerate to get it to boost. Boost gauge normally goes up to about 0.4 bar.

ppoizenmoderator26 Mar 2010, 10:27

yes i know but if you accelerate slowly you can get to 5000rpm withour boosting or doing 0.1 bar

RRichard26 Mar 2010, 10:28

yes can be done.

rratadmin26 Mar 2010, 10:44

I had a small hole in the rubber fuel line in the tank so under load or going into boost would do what you are saying but I could rev all the way to 6000rpm if i just lightly pressed the pedal.

RRichard26 Mar 2010, 11:18

Let me inspect the fuel lines, boost pipes and vacuum pipes on the weekend and will let your'll know if i find anything.

CCharlvdw26 Mar 2010, 12:31

rat wrote:

I had a small hole in the rubber fuel line in the tank so under load or going into boost would do what you are saying but I could rev all the way to 6000rpm if i just lightly pressed the pedal.

Same symptoms here but my pump was moeg.

SSnoobY13 Apr 2010, 16:33

i had the same thing just clean the air flow sensor, worked for me.

RRichard14 Apr 2010, 08:38

Have not had time to check the car yet, however I will use your suggestions and try everything and let your'll know what happens

DDracomoderator23 Jun 2010, 08:45

Verdict?

RRichard23 Jun 2010, 13:25

Howzit, checked all, points to power transistor, not 100% sure though.

DDracomoderator23 Jun 2010, 13:40

Does it still do it....or should I say...did it still do it...

RRichard23 Jun 2010, 14:59

Yes it does, hadn't had time to strip stuff and check properly.

31 posts

Sign in to reply.